Products and Component Restoration

Home » Reproduction Parts & Specialty Coatings » Body 1969-70 B-body N96 Hood Hinge Spring Details  Accurate reproduction of the special heavier hood hinge springs used on N96 Air Grabber hood optioned 1969-70 B-body Mopars. Exact wire gauge, coil count & outside diameter. Price is for one pair of springs. Price: $75.00 1971-72 B-body N96 Hood Hinge Spring Details  Accurate reproduction of the special heavier hood hinge springs used on N96 Air Grabber hood optioned 1971-72 B-body Mopars. Exact wire gauge, coil count & outside diameter. Price is for one pair of springs. Price: $75.00 Large Flange Rivet Details  Special steel large flange pop rivet as used on front frame rail splash shields and 69 Roadrunner & Superbee air grabber hood air induction ductwork. Also available in aluminum as used on Superbird and Daytona nose areas. Type Price Adj Please Select...Aluminum Steel Price: $0.50 Mirror Threaded Insert Details  10-24 threaded steel insert as used to fasten door mirror and rear window louvers. Requires use of a threaded insert installation tool. A low-buck alternative is to use a 10-24 hex headed screw with a flat washer and a hex nut. The screw is threaded into the insert with the hex nut threaded on the screw. While holding the screw to prevent it from turning, the hex nut is tightened to compress the threaded insert. The insert must be held tightly to the sheetmetal as the nut is tightened. Price: $1.00 Push Retainer Details  Push retainer as used on A-body hood hinges (4 required) and E-body trunk hinges (2 required). Price is each. Price: $1.00