Restorations by Rick Kreuziger
Restorations by Rick Kreuziger
Home | Profile | Active Topics | Members | Search | FAQ
 All Forums
 General
 Assembly Line Errors & Deviations
 Shaker Cable Firewall Hole

Note: You must be registered in order to post a reply.

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
Rick Posted - 06/08/2004 : 22:09:09
This first picture is of the dimple next to the shaker cable firewall hole that was incorrectly drilled. The hole then had a patch of sheetmetal tack brazed over the hole. Factory paint covered the "repair". Inside the firewall a rust trail formed from water getting into the car! (1971 'Cuda)
Rick



This next picture shows the dimple next to the shaker cable firewall hole that was pilot drilled. (1971 'Cuda)
Rick


Restorations by Rick Kreuziger © 2000-04 Snitz Communications Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.04