Restorations by Rick Kreuziger
Restorations by Rick Kreuziger
Home | Profile | Active Topics | Members | Search | FAQ
 All Forums
 General
 Assembly Line Errors & Deviations
 Spring Hanger reinforcement plate

Note: You must be registered in order to post a reply.

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
Rick Posted - 06/05/2004 : 13:36:00
Here's a spring hanger reinforcement plate found on a 1970 Challenger convertible. The plate was welded in upside down. Because the hole spacing is different from the top to bottom the holes had to be "egged" out to allow the spring hanger installation.
Rick Kreuziger


Restorations by Rick Kreuziger © 2000-04 Snitz Communications Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.04