Restorations by Rick Kreuziger
Restorations by Rick Kreuziger
Home | Profile | Active Topics | Members | Search | FAQ
 All Forums
 General
 Bodywork & Sheetmetal
 Stamping Plant Grading Scale

Note: You must be registered in order to post a reply.

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
   

T O P I C    R E V I E W
Rick Posted - 02/03/2005 : 23:35:16
I had the opportunity several years ago to speak with a gentleman who worked for a Ford Motor Company body panel stamping plant. The most interesting thing I learned from him was that they used a grading scale system to rate the quality of panels they stamped. I donít recall the designations, but basically they started with the best rating for use on black cars. The panel grading diminished from there down through medium colors and white of course was toward the bottom, however, not AT the bottom. The bottom or lowest quality grading was reserved for, (drum roll please!) Ö service replacement partsÖ those highly sought after NOS body panels everyone fights over these days! I havenít installed a single NOS body panel that didnít have some flaw or most often several flaws that wouldíve made its use impossible on an assembly line. So in an ideal world scenario, one wants an original paint panel from a black or dark colored car.

Rick Kreuziger

Restorations by Rick Kreuziger © 2000-04 Snitz Communications Go To Top Of Page
Powered By: Snitz Forums 2000 Version 3.4.04